Ambersil HS 300 High Strength Spray Adhesive – A high strength adhesive, formulated without Methylene Chloride or other chlorinated solvents.
- High strength formulation.
- Longer open bond time – allows large areas to be covered before film dries.
- Economical, good coverage.
- Free from chlorinated solvents.
Spray Adhesive HS 300 will provide high-strength bonds in many different areas:
- Chipboard and Concrete.
- Insulation Materials.
- Canvas and Leather.
- Paper, Wood and Cork.
- Metal, Plastic and Rubber.
Apply an even coating to both surfaces to be bonded from 9 – 12 (25 – 30cm). Wait until the adhesive is tack-dry and bond the surfaces together using firm pressure.
N.B. May affect certain plastics. Always test a small, inconspicuous area before general use. To prevent blockages, invert the can after use and spray to clear the nozzle.
Appearance: Clear, amber liquid.
SG @ 25°C: 0.68.
Pressure @ 25°C: 3 Bar.
Discharge rate: 1.7 g/sec.
Polymer type: Styrene Isoprene Copolymer.
Tack time: Approximately 2-10 minutes.
Bonding time: Maximum adhesion in 12/24 hours.
Temperature range: Up to 50°C (dried film).
Solubility: Soluble in some solvents, insoluble in water.
Recommended solvents: Amberklene FE10, ME20 and L030.
Flammability: Classified as extremely flammable under CHIP Regulations.
Packaging: 500ml aerosol.
14 Day Peace of Mind Returns
We know that sometimes you change your mind after placing an order online, that's why we offer a 14 day peace of mind returns policy.
Got a Question?
Why not check out our range of Frequently Asked Questions, or contact our team via phone or email for more specific advice.